1. Small mixer has fixed type and mobile type. Fixed mixer in the use of it must find a solid foundation, mobile mixer in the use of some things to fix, but also to keep it in a horizontal state.

2、在使用操作的時候記得檢查攪拌機的各個裝置、零件是否正常，以保證其工作的正常進行。確保工作裝置、防護裝置處于正常狀態，觀察三角膠是否是適當的松緊度，攪拌軸兩端是不是處于密封的狀態。

2. When using and operating, remember to check whether the various devices and parts of the mixer are normal to ensure the normal operation. Ensure that the working device and protective device are in normal state, observe whether the triangle glue is in proper tightness, and whether both ends of the mixing shaft are in sealed state.

3、在啟動攪拌機后，先不要加材料，讓它先空轉一會。，在確認攪拌葉的轉動是正確的方向之后，再加入要使用的原料。另外，如果原料是砂子，那么砂子一定要篩過之后再放入，以免對其造成破壞。

3. After starting the blender, do not add any material, let it idle for a while., After confirming that the rotation of the mixing blade is in the right direction, add the raw material to be used. In addition, if the raw material is sand, then the sand must be sifted before it is put in, so as not to cause damage to it.

4、在攪拌機正常工作的時候，一定要注意安全，不要講手伸入其內，不要在筒口進行作業，也不要將其它棍棒之類的東西放入其中。在工作過程中，如果出現了一些使攪拌機不能正常工作的故障，要及時的拔掉電源，讓攪拌機停止工作后將里面的所有灰漿清理干凈，查處故障來源，修理好后再讓攪拌機進行工作。

4. In the normal operation of the mixer, we must pay attention to safety, do not put your hand into it, do not work at the mouth of the cylinder, and do not put other sticks and other things into it. In the process of work, if there are some faults that make the mixer unable to work normally, it is necessary to unplug the power supply in time, clean up all the mortar inside after the mixer stops working, investigate the source of the fault, and let the mixer work after repair.

5、在攪拌機工作完畢后，斷開電源，將攪拌機里面的灰漿、原料等等剩余物，全部倒出來，將它的里面用清水清洗干凈，這是保養攪拌機應該做的工作。

5. After the mixer is finished, cut off the power supply, pour out all the mortar, raw materials and other residues in the mixer, and clean it with clean water. This is the work that should be done to maintain the mixer.